Process Engineer
EDGE
full-time
Posted on:
Location Type: Office
Location: Abu Dhabi • United Arab Emirates
Visit company websiteExplore more
About the role
- Plan machining processes by studying work orders, blueprints, 3D models, wire frame models, engineering drawings, material specifications, reference planes, locations of surfaces and machining parameters.
- Applies statistical methods and performs stack-up calculations to determine optimized manufacturing processes in terms of safety, quality, repeatability and cost.
- Proactively resolves problems—technical, planning, or product quality—to maximize process repeatability, and minimize cost of production.
- Contributes and takes ownerships in the generation of PFMEA documents.
- Read and produce engineering drawings according to different international standards with a sound knowledge of GD&T.
- Prepares/modifies technical drawings, specifications, calculations, visual aids and any other documentation for production instruction or fixture definition.
- Supports in the design and modification of tooling and fixtures.
- Delivers results on any business support project (i.e. cost saving, industrialization, NCR, Mods) on time and within budget.
- Prepare and maintain work Instructions to support production operators.
- Issues engineering official communication to production staff when an approved deviation is taken from work instructions.
- Works within the limits of authority as defined by the Manufacturing Engineering Procedures getting adequate approvals with deviations are required.
- Observes test cuts and FAIs during manufacturing processes.
- Create or modify Process Flow Charts, covering all manufacturing process steps.
- Releases rework sequences in the ERP system, providing adequate instructions as required.
- Record and project manage all actions required to close any assigned engineering change proposal (ECP) successfully.
- Maintains an error-free configuration in the PLM and ERP systems for any assigned part numbers.
- Work independently with minimal supervision.
Requirements
- Bachelor’s degree in aerospace, Automotive, Mechanical or Manufacturing Engineering
- PMP, Six Sigma or Lean Manufacturing certification preferred.
- Minimum 5 years of relevant experience in the aerospace or automotive industries.
- Demonstrated track record of implementing process improvement to enhance efficiency, eliminate waste and reduce costs.
- Experience using CATIA V5 and/or Siemens NX.
- Familiarity with non-conformance processes.
Applicant Tracking System Keywords
Tip: use these terms in your resume and cover letter to boost ATS matches.
Hard Skills & Tools
machining processesstatistical methodsstack-up calculationsPFMEAGD&Ttechnical drawingstooling designProcess Flow Chartsrework sequencesengineering change proposal
Soft Skills
problem resolutionownershipcommunicationindependenceproject management
Certifications
Bachelor’s degree in aerospace engineeringBachelor’s degree in automotive engineeringBachelor’s degree in mechanical engineeringBachelor’s degree in manufacturing engineeringPMPSix SigmaLean Manufacturing