Quality Assurance Tester
Adobe
full-time
Posted on:
Location Type: Office
Location: Brighton • Colorado • 🇺🇸 United States
Visit company websiteSalary
💰 $30 - $39 per hour
Job Level
Mid-LevelSenior
Tech Stack
Assembly
About the role
- Test safely, according to all procedures, is the #1 priority as there are high hydraulic pressures and high voltages in test.
- Control and test an assembled, or pre-assembled product in production; make quality control of the product to ensure no failures pass through to the next level and/or supplier.
- Verify adherence to Vestas quality and testing standards before allowing product to takt to next operation.
- Perform assembly / process work in operation for which he/she is responsible for, as needed; normally will be perform non-standard work and will cover operations in the event of absences.
- Problem-solving by trying to diagnose test failure issues.
- Point of contact within operation for process/product engineering changes.
- Ensure NCR reports is made, as regarding product/assembly not meeting Vestas quality specifications.
- Inspect product to determine compliance with order specifications, company’s quality control system for compliance.
- QDA entry; stamp mark of approval or rejection with QDA on product and write report.
- Provide customer service by responding to requests for service and assistance.
- Listen and obtain clarification; responds well to questions.
- Teamwork - gives and welcomes feedback.
- Ethics - Upholds organizational values. Follows organizational policies and procedures. Demonstrate accuracy and thoroughness; Apply feedback to improve performance.
- Observe safety and security procedures; determine appropriate action beyond guidelines; report potentially unsafe conditions; use equipment and materials properly.
- Other duties as assigned.
Requirements
- Journeyman or Master Electrical license and 4 years’ hands-on experience OR documented electrical education (i.e. Associates degree in Electrical Engineering, Trade school certificate of graduation, Bachelor’s degree in electrical engineering) and 4 years’ hands-on experience OR documented military-equivalent technical training with electrical system, (i.e. Avionics, Power Production, Civil Engineering) and 4 years’ hands-on experience.
- Note: experience must be with industrial or commercial electrical equipment including maintenance and troubleshooting 3 phase systems and controls.
- Annual refresher courses in electrical and hydraulic safety training
- Knowledge of Manufacturing software and Spreadsheet software
- Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.
- Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.
- Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form.
- Ability to deal with problems involving several concrete variables in standardized situations.
Applicant Tracking System Keywords
Tip: use these terms in your resume and cover letter to boost ATS matches.
Hard skills
electrical systems3 phase systemstroubleshootingquality controlassemblyprocess engineeringhydraulic safetymanufacturing softwarespreadsheet softwareQDA entry
Soft skills
problem-solvingcustomer serviceteamworkcommunicationattention to detailethicsadaptabilityfeedback acceptanceclarificationsafety awareness
Certifications
Journeyman Electrical licenseMaster Electrical licenseAssociates degree in Electrical EngineeringTrade school certificateBachelor’s degree in Electrical Engineeringmilitary-equivalent technical training