Perform diversified assembly, rework, repair, inspection and/or basic test on electronics and/or mechanical assemblies.
Capable of using a broad range of power and hand tools.
Move material using appropriate equipment.
Performs data entry and general recordkeeping.
Assemblers are required to comply with departmental safety requirements, contribute to the quality improvement process, interface, and communicate within the department/division as a function of the position.
Test Execution and debug module builds.
Ability to problem solve through creative and analytical thinking.
Identify root causes and pursue corrective actions to prevent reoccurrence of faults on assembly builds.
Work closely with Engineering and NPI groups to obtain resolutions to issues encountered.
Documenting, troubleshooting and isolating moderate to complex problems.

Requirements

Associate degree in electrical engineering, or equivalent, required.
Knowledge and experience with signal generators, digital multi-meters, oscilloscopes, etc.
Ability to work independently on time bound projects.
Knowledge of both analog and digital circuits and experience with component-level debug of PCB assemblies.
Knowledge of Windows, Client Office, Adobe Reader, understanding BOMs, Revision controls, and ECO's is preferred.
Knowledge of six sigma, lean manufacturing, 5S practices, Quality Control problem solving tools and PCBA manufacturing problem is a plus.
Experience with RF products and Silicon Photonics is a plus.

Benefits

📊 Check your resume score for this job Improve your chances of getting an interview by checking your resume score before you apply. Check Resume Score

Applicant Tracking System Keywords

Tip: use these terms in your resume and cover letter to boost ATS matches.

Hard Skills & Tools

assemblyreworkrepairinspectiontest executiondebugginganalog circuitsdigital circuitscomponent-level debugPCBA manufacturing

Soft Skills

problem solvingcreative thinkinganalytical thinkingcommunicationindependencetime management

Certifications

Associate degree in electrical engineering